Binding Installation Guide

Congratulations on your new set of Union bindings. Bindings are the most important piece of snowboarding equipment that you own. That being said, it’s crucial that they are set up properly to ensure optimal fit and performance. This guide will give you all the info you need to dial in the proper boot-to-binding fit. If this is your first time setting up a snowboard, we highly suggest going into an authorized Union dealer for assistance.

Select your Product:

Explorer FC

Atlas FC

Explorer

Atlas Super Pro

Spring Break Snowboards

Falcor

Atlas

Danny Kass

Jamie Anderson

Legacy

Strata

Force Pro

Trilogy

Force

Contact Pro - SB

Milan

Contact Pro

Juliet

STR

Rosa

Flite Pro

Cadet PRO

Cadet

Cadet XS

Universal Steps

Disk Guide

Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi u...

Stance - Regular or Goofy

Size Chart

Stance - Width and Angles

Components

Tools Needed

Binding Adjustments

Snowboard boots come in all shapes and sizes. To ensure the best per- formance possible, we suggest adjusting your bindings before you mount them to your snowboard. Follow the guide below for the best possible boot-to-binding fit.

Heelcup Adjustment

Toe Strap Adjustment - Toe Cap vs. Over The Top

Toe Strap Adjustment - Boot Length

Highback Adjustment - Rotation

Disk Cover Adjustment

Toe Strap Adjustment - Centering

Ankle Strap Adjustment - Centering

Highback Adjustment - Forward Lean

Mounting Your Bindings

1. Remove the disk cover screw.
2. Slide the disk cover out and place to the side.
3. Place the disk into the center of the binding at your desired stance angles.
4. Align the disk with the board's inserts that you plan on using.
5. If mounting to a 4x2 or 4x4 pattern, use the 4 large Power Washers and 8 screws.If mounting to the Channel use the 4 standard washers and 4 screws.
6. Using a #3 Phillips screwdriver, hand thread each screw with a washer into place.
7. Start with one full turn on each screw, then contin- ue tightening one full turn each while alternating screw to screw until all screws are equally tight.
8. Slide the disk cover to your desired setting and rethread the screw to secure.

Tech Tip

If you're having a hard time getting your screws to reach the inserts, begin by threading one screw with no washer. This will pull the binding closer to the top sheet and allow you to easily thread the remaining screws and washers. Once you have threaded the remaining screws, take out the first screw and reth- read with a washer.